DAD Stacked Letters Pop Card

Four “slices” are reconfigured to align directly 

in a column to allow bottom tabs to fit 

into sturdy base with slots. 

Front slice is decorated with “D” “A” & “D” 

plus leafy stems, shaded oval berries to celebrate 

Father’s Day, birthday, or other commemorative 

or festive occasions. 

Folded flat, card assembly can fit into 5x7 envelope 

for neatly packaged giving. 

Coordinated “Env Leaf Berry” envelope 

design is also available.

ASSEMBLY: 1. Identify and cut the shapes:

A front "offset" panel   B letters overlays for "D A D"

C front pop up panel (with attachment tabs at bottom)

D center pop up panels (2) with flat bottom edges

E back pop up panel (with bottom positioning nib)

F back offset panel overlay

G "bridge" strips which connect slice panels (4)

H base panel with nib slots   I reversed base bottom panel

J base overlay with slots for attaching front pop up panel

K opt. sentiment panel to place on base bottom

L & M berry base with overlay (3 sets of each style)

N sprigs large and single

NOTE that assembly of this card is very similar

to the "MOM Stacked Letters Pop Card". Most of

the steps can be followed from that tutorial by

following this LINK.

2. Go to the "MOM" card post to complete Step 2, then

refer to the following illustrations and photos as substitutes

for Steps 3-6. Complete Step 7 as shown for "MOM" card.

3. Position the tall sprig at left bottom and side where 

offset front panel overlay indicates tip and first leaf 

will fit, and attach the 2 leaves and below ONLY.

4. Position and attach the lower 'D'.

5. Prepare to attach the 'A' by threading

the vine up through the "hole" of the 'A' . . .

. . . and sliding the letter down into it's

final position, and attach 'A' there.

Before gluing the vine down the stem end

of the two smaller vine branches will need to be

tucked under the vine, so leave it free for a bit.

6. Position the top 'D' in place, taking care

that the vine leaves overlap the letter

as shown, then attach remaining shapes

in place.

Finally, tuck the upper short vine stem under

the 'A' upper body, with upper leaves overlapping

the top 'D'. Then position . . .

. . . the lower short stem overlapping the bottom of 'A'.

Tuck the ends of both these shorter vine stems

under the original main vine and glue all remaining.

Refer to Step 7 of "MOM" card to assemble and position

the berries (DAD card has more berries).

Here is how the "DAD" card front panel should appear.

Return to the "MOM" card version by following the LINK

to complete the remaining steps through

Step 19 to complete the card assembly.